1．Outline Of The F395; What The F395 Can Do - Unipulse f395 Operation Manual

1. Outline of the F395

1-1. What the F395 Can Do:

START
STOP
The procedures from waveform display to uses of the Multi-Hold function and Waveform Comparison
function are as follows:
Request
The Multi-Hold / Hysteresis / Hysteresis 2 / Waveform Comparison / Waveform and
Displacement Comparison functions cannot be used simultaneously.
Carefully read the explanations of "7. Measurement Operation Functional Settings" P40,
"10. Multi-Hold Mode" P47, "11. Hysteresis Mode" P64, "12. Hysteresis 2" P65, "13.
Waveform Comparison / Waveform and Displacement Comparison Mode" P68 and select
function(s) appropriate for the equipment application you use.
Waveform display of signals from a
strain gauge type sensor;
Detection of points in a waveform such
as an inflection point
(Multi-Hold function);
Sampling of waveform variation with
displacement for going and return,
detection of points in a waveform such
as an inflection point, and judgment of
differences between going and return
at a given point
(Hysteresis / Hysteresis 2 function);
Check to see if the waveform variation
with time and displacement is within a
certain width
(Waveform Comparison / Waveform
a n d D i s p l a c e m e n t C o m p a r i s o n
function).
Basically, the waveform between the START signal and STOP
signal is graphically drawn.
(Conditional. See "9. Method of Starting Measurement" P43.)
1.Outline of the F395
Connection (P.21 )
Calibration (P.31 )
Settings Relating to Indicated
Value (P.38 )
Reading of Waveform (P.92 )
Measurement Operation
Functional Settings (P.40 )
Multi-Hold, (P.47 )
etc.
Hysteresis (P.64 )
Hysteresis 2 (P.65 )
etc.
Waveform Comparison /
waveform and Displacement
Comparison, (P.68 )
etc.
Strain gauge type sensor
2