Auto Code Up / Code Up Point - Unipulse f395 Operation Manual

16.Code Setting

16-2-5. Auto Code Up / Code Up Point

In the Multi-Hold / Hysteresis / Hysteresis 2 mode, if the Auto Code Up is set to "ON",
switching of the operation ch is brought into Auto Code Up mode. By using the Auto
Code Up Mode, the operation ch can automatically be updated during sampling in the
Multi-Hold / Hysteresis mode, and hold is executed by the Auto Code Up timing in the
Hysteresis 2 mode (in exchange for Pulse Hold). Set the operation ch update timing in
the Auto Code Up mode under Code Up Point. For details of the Auto Code Up mode,
see "2. Setting by the auto code up function" in "16-1. Method of Setting the Operation
ch" P100.
Auto Code Up
Code Up Point
In the Multi-Hold mode
In the Hysteresis / Hysteresis 2 mode
107
Setting item: ON / OFF
Setting range: 0 ~ 9999
Multi-Hold mode:
Setting unit = One-time sampling time
Hysteresis / Hysteresis 2 mode:
Setting unit = Amount of displacement
MODE → Code Set
MODE Code Set
→
Y
Operation ch 0 Operation ch 1
Code up point
on operation ch 0
(relative to the X-axis measured value)
→ Basic:
Auto Code Up
Code Up Point
→ Basic: PAGE →
Operation ch 2 Operation ch 3
Code up point on
on operation ch 2
Code up point on
on operation ch 1
Auto Code Up
Code Up Point
X