Setting Section; Input / Output Section; External Power Supply (Shared With Excitation Voltage); Interface - Unipulse f395 Operation Manual

23-4. Setting Section

Setting method:
Initial settings

23-5. Input / Output Section

・ Input signals (24 points):）ON when short-circuited with the COM terminal by
・ Output signals (16 points): Transistor open collector output (Emitter=COM terminal)
・ Analog output:

23-6. External Power Supply (Shared with Excitation Voltage)

Power can be supplied by the following method when the analog input is set to voltage/
current.
・ 5V DC.
120mA can be supplied in total with excitation voltage of other channels.
・ +EXC and the ground side of the analog output are used.

23-7. Interface

・ 2-wire serial interface (SI/F)
・ RS-232C
・ Device Net (option)
・ CC-Link (option)
By analog type touch panel operation.
Initial settings: NOVRAM (Nonvolatile RAM)
Other settings: Lithium-battery-backed-up C-MOS RAM
contact (relay, switch, etc.) or non-contact (transistor,
opencollector, etc.)
Output ON with transistor ON.
Approx. 2V relative to 1mV/V load cell input
Approx. 5.6V relative to 5V voltage input
Approx. 5.2V relative to 20mA current input
(Load resistance: 5kΩ or more)
23.Specifications
158