Unipulse f395 Operation Manual page 93

13.Waveform Comparison / Waveform and Displacement Comparison Mode
・ Hold is detected over the period from the start to the end of sampling (at sampling-
・ The hold detecting method is the same as in the Multi-Hold mode (using the T/H
・ The hold state is maintained even after completion of sampling by keeping the T/H
・ For High/Low Limit Judgment with the hold point, the HI-HI Limit / LO-LO Limit
・ COMPLETE is output with respect to Waveform Comparison / Waveform and
・ The hold point is displayed with an orange "+" mark on the graph (the last one point
・ By turning on the input "Display after measurement", the last sampling value is held
・ When hold operation is not performed, real-time High/Low Limit Judgments are made
・ For details of the main screen, and waveform reading / rejected waveform reading
79
time). Hold detection is performed only at sampling-time.
signal).
signal ON. (The hold can be cancelled by turning off the T/H signal.) Also, the hold is
reset by the timing of starting the next sampling even if the T/H signal is kept ON.
setting is used, and the results of judgment is output to LO2/OK2/HI2. (For hold
operation and judgment of the hold point, the inhibit timer is effective.)
Displacement Comparison. Therefore, check the results of Judgment of the hold point
at the end of sampling and by the timing of turning off the T/H signal.
only). HI-HI Limit and LO-LO Limit lines are not displayed.
even without hold operation, but no "+" mark is displayed on the graph.
on the sampling value with the HI-HI Limit / LO-LO Limit.
screen, see "2-1-1. Touch Panel Type Color Liquid Crystal Display" P7.