Unipulse f395 Operation Manual page 40

・Capture start by external signal:
Sampling is started by the rising edge of the START input irrespective of the
Waveform Start Level when this signal is ON.
(See "9. Method of Starting Measurement" P43
・ Waveform termination level operation:
Sampling is stopped by the Waveform Termination Level when this signal is ON.
(See "16-2-9. Level Axis Select / Waveform Start Level / Waveform Termination
Level / Hold Start Level" P113.)
・Prohibit touch panel:
The touch panel is prohibited when this signal is ON.
・Displacement hold cancel:
The displacement peak value for Displacement High/Low Limit Comparison is
cancelled when this signal is ON. (See "16-2-8. Displacement High-low Mode /
Displacement High Limit / Displacement Low Limit / Displacement Hold High Limit
/ Displacement Hold Low Limit" P110.)
・Backlight ON:
The backlight is lit when this signal is ON. If it is kept ON, the backlight will not go
out.
・Select HH/LL:
Selects operation of HH/LL output (pin 20).
When this signal is OFF:
When this signal is ON:
・ Reset auto code up:
The Auto Code Up mode is canceled by turning this signal ON after completion of
sampling as follows:
- The operation ch is reset.
- The reference values for High-Low Relative Comparison are cleared.
- Hold reset by T/H and H/M becomes executable.
・ D/Z:
Digital Zero is performed by the ON edge. (See"6-4. Digital Zero" P39.)
・T/H, H/M:
Directs the timing of hold operation. (See "10-3. Hold Functions" P48.)
・ START, STOP:
Directs waveform drawing operation.
(See "9. Method of Starting Measurement" P43)
・HOLD1 ~ 3:
Pulse input 1 ~ 3 for Pulse Hold / Hysteresis 2.
(See "10-3-10. Pulse Hold" P62, and "12. Hysteresis 2" P65.)
*1
Accumulated : When multiple operation channels are switched, once HI2 / LO2 results,
HI2 / LO2 remains ON, and OK2 turns OFF.
Result of judgment on the currently set operation ch.
*1
Accumulated result of judgment on the pre-switching
operation ch.
4.Methods of Connection
26