Sampling Reset; X/Y-Axis Setting By Operation Mode And Input Ch - Unipulse f395 Operation Manual

7.Measurement Operation Functional Settings

7-3. Sampling Reset

If CH1/CH2 input calibration, Operation Mode, or PUI setting (optionally mounted) is
changed, the F395 stops sampling, and moves to a sampling waiting condition.
At this time, the results of hold / comparison are also reset.

7-4. X/Y-axis Setting by Operation Mode and Input CH

Analog input CH1/CH2 functions as X/Y-axis analog input depending on the Operation
Mode.
* Set CH1/CH2 under Select Analog CH. (See "16-2-3. Select Analog CH" P104.)
The current X/Y-axis setting of CH2 can be confirmed by the Axis setting on the CH2
Input Calibration screen. (The setting cannot be changed by this item.)
41
About advance waveform display
When the operation mode is Multi-Hold or Waveform Comparison, a
waveform is displayed gradually without waiting for completion of taking-
in of the waveform by setting the sampling rate to 100Hz or 200Hz.
The display rate changes according to the X-axis scaling.
This function simply handles waveform data, and hold points are
displayed after measurement.
The previous waveform is dismissed when the next measurement starts.
(The waveform can be read.)
Advance display is not carried out unless the main screen is displayed
when a measurement starts.
Operation Mode
Multi-Hold
Wave Comp
Hysteresis
Wave&Displace
Hysteresis2
Y-axis X-axis
CH1/CH2
CH1/CH2
CH1
(displacement input)
CH1
(displacement input)
CH1
(displacement input)
Time
Time
CH2
CH2
CH2