Waveform Comparison; Waveform And Displacement Comparison Procedures; Operation Mode At A Glance - Unipulse f395 Operation Manual

1.Outline of the F395

1-6. Waveform Comparison /

Waveform and Displacement Comparison Procedures

In the Waveform Comparison / Waveform and Displacement Comparison mode,
waveform variations with time / displacement are sampled, and a High/Low Limit
Comparison is performed based on the sampled waveform.
A sequential comparison can be performed with respect to dynamic waveform
variations.
The procedures for performing a Waveform Comparison / Waveform and Displacement
Comparison are as follows:
1. Check to see if a waveform is displayed in accordance with the waveform drawing
2. Carry out Waveform Comparison / Waveform and Displacement Comparison settings.
3. Select the channel number(s) you want to control externally.
4. Provide a load to the strain gauge type sensor (displacement sensor), input START and

1-7. Operation Mode at a Glance

Operation
mode
Time Sensor Pulse
Multi-Hold
Hysteresis
Waveform
Comparison
Waveform and
Displacement
Comparison
Hysteresis 2
5
procedures. (See "1-2. Waveform Drawing Procedures" P3.)
(See "13-2. Setting and Operating Method" P68.)
(See "4-3. Control Connector Connection" P25.)
other signals, and check to see if operation is performed as set.
Usable X-axis Maximum
sampling
rate
4kHz
○ × ×
2kHz
× ○ ○
4kHz
○ × ×
2kHz
× ○ ○
2kHz
× ○ ○
Waveform
Hold
comparison
9 points for all types
9 points for all types
1 point for three types
1 point for three types
3 points for one type
Capability
of return
× ×
× ○
○ ×
○ ×
× ○