Analog Input / Output Connection; 4-1-1-1.Analog Input / Output Terminal Pin Assignments - Unipulse f395 Operation Manual

4.Methods of Connection

4-1-1. Analog Input / Output Connection

4-1-1-1. Analog Input / Output Terminal Pin Assignments
1 FG
2 ＋ EXC
3 － SIG
4 － EXC
5 ＋ SIG
6 V-OUT
7 N.C
* 1 ~ 6 are input / output terminals for CH1.
8 V-OUT
9 GND
10 ＋ EXC
11 － SIG
12 － EXC
13 ＋ SIG
14 FG
* 8 ~ 14 are input / output terminals for CH2. (Pin 9 is common to CH1 and CH2.)
Request
21
: Frame ground. Terminal to connect the shield of sensor
connection cabling.
: Terminal to connect a strain gauge type sensor.
: Terminal to connect a strain gauge type sensor or displacement
sensor.
: Terminal to connect a strain gauge type sensor.
: Terminal to connect a strain gauge type sensor or displacement
sensor.
: Terminal that outputs voltage proportional to sensor input.
The voltage output is approx. 2V per 1mV/V sensor input, and
the load resistance is 5kΩ or more
: Terminal that outputs voltage proportional to sensor input.
The voltage output is approx. 2V per 1mV/V sensor input, and
the load resistance is 5kΩ or more.
: GND terminal for the V-OUT terminal. (Common to pin 6 and
pin 8.)
: Terminal to connect a strain gauge type sensor.
: Terminal to connect a strain gauge type sensor or displacement
sensor.
: Terminal to connect a strain gauge type sensor.
: Terminal to connect a strain gauge type sensor or displacement
sensor.
: Frame ground. Terminal to connect the shield of sensor
connection cabling.
The CH1 and CH2 input sensor specifications (strain gauge/current/
voltage) are factory-shipped settings. For changing the settings,
contact us since modifications are required. CH1 corresponds to a
strain gauge, and CH2 corresponds to voltage as a standard.