Display After Measurement - Unipulse f395 Operation Manual

13.Waveform Comparison / Waveform and Displacement Comparison Mode
When the setting is "OFF"

13-9. Display After Measurement

Measurement display upon completion of comparison can be selected by the input
"Display after measurement" from the following.
(See "4-3-2. Input and Output Signals" P25.)
1. Input "Display after measurement" ON: The last value is held.
2. Input "Display after measurement" OFF: Real-time display.
81
Nothing is output.
High limit
Low limit
When the setting is "OFF"
・ The result of the previous judgment is cleared when the START
signal is turned on.
・ No output will also result if sampling starts after the end point.
(The held value is canceled when the next sampling starts.)
Comparison area
The results are maintained.
Start point End point
Input waveform