Unipulse f395 Operation Manual page 84

13.Waveform Comparison / Waveform and Displacement Comparison Mode
2. Set 100Hz under "Sampling Rate". However, it is normally 2kHz in the Displacement
mode. For use in the Displacement mode, operations in "5." ~"9." are unnecessary,
therefore perform operation in "10." after "3." and "4.".
MODE Operation Mode
→
3. Set "Waveform Start Level" and "Waveform Termination Level" at the desired ch (0 ~
15).
Waveform Start Level: Normally set a value close to zero (approx. the increment ×
MODE → Code Set → Basic: Wave Start Level / Wave End Level
4. Set desired channel(s) with external channel selection signals.
Example: 5ch
Control connector
10 COM
11 CODE1
12 CODE2
13 CODE4
14 CODE8
36 CODE16
5. Exit the setting menu, go to the main screen, input the START signal externally, and
then input a test waveform.
A waveform is input in synchronization with the
"Waveform Drawing" function.
For details, see "9. Method of Starting Measurement" P43.
Sample Rate
→
10). Set a slightly larger value if noise is large.
Request
Open CODE16.
(Do not use.)
70