Epson RC620 Safety And Installation page 47

■ Be sure to connect the AC power cable to a power receptacle. DO
NOT connect it directly to a factory power source. To shut off power
to the robot system, pull out the power plug from the power source.
Performing any work while connecting the AC power cable to a factory
power source is extremely hazardous and may result in electric shock
and/or malfunction of the robot system.
■ Before performing any replacement procedure, turn OFF the Controller
and related equipment, and then pull out the power plug from the
power source.
Performing any replacement procedure with the power ON is
extremely hazardous and may result in electric shock and/or
WARNING
malfunction of the robot system.
■ Be sure to connect the cables properly. Do not allow unnecessary
strain on the cables. (Do not put heavy objects on the cables. Do
not bend or pull the cables forcibly.) The unnecessary strain on the
cables may result in damage to the cables, disconnection, and/or
contact failure. Damaged cables, disconnection, or contact failure is
extremely hazardous and may result in electric shock and/or improper
function of the robot system.
■ Carefully use alcohol, liquid gasket, and adhesive following respective
instructions and also instructions below.
liquid gasket, or adhesive may cause a fire and/or safety problems.
- Never put alcohol, liquid gasket, or adhesive close to fire.
- Use alcohol, liquid gasket, or adhesive while ventilating the room.
- Wear protective gear including a mask, protective goggles, and
CAUTION
- If alcohol, liquid gasket, or adhesive gets on your skin, wash the
- If alcohol, liquid gasket, or adhesive gets into your eyes or mouth,
Safety and Installation (RC620 / EPSON RC+ 6.0) Rev.12
oil-resistant gloves.
area thoroughly with soap and water.
flush your eyes or wash out your mouth with clean water thoroughly,
and then see a doctor immediately.
Careless use of alcohol,
1. Safety
33