Epson RC620 Safety And Installation page 10

Before Reading This Manual
Do not connect TP1 to the following Robot Controllers. Connecting to
the following Robot Controllers may result in malfunction of the device
since the pin assignments are different.
RC90 / RC420 / RC520 / SRC5** / SRC-3** / SRC-2**
Be careful of the operating instructions of the TP1 when connecting it to
the Robot
Controller RC180, it is different from the explanation in this manual.
When using the TP1 with the RC180, refer to theRC180 Option Teach
Pendant TP1.
Do not connect the followings to the TP port of RC620. Connecting to
the followings may result in malfunction of the device since the pin
assignments are different.
Concerning the security support for the network connection:
The network connecting function (Ethernet) on our products assumes the
use in the local network such as the factory LAN network. Do not
connect to the external network such as Internet.
In addition, please take security measure such as for the virus from the
network connection by installing the antivirus software.
Security support for the USB memory:
Make sure the USB memory is not infected with virus when connecting
to the Controller.
viii
OPTIONAL DEVICE dummy plug
Operation Pendant OP500
Operator Pendant OP500RC
Operator Panel OP1
Jog Pad JP500
Teaching Pendant TP-3**
Teach Pendant TP2
Safety and Installation (RC620 / EPSON RC+ 6.0) Rev.12