Single Range Mode - Teledyne 400E Instruction Manual

Operating Instructions
To select the Analog Output Range Type press:
SAMPLE
< TST TST > CAL
SETUP X.X
CFG DAS
SETUP X.X
MODE
SETUP X.X
SNGL DUAL AUTO
Go To
Section

6.5.3. Single Range Mode

This is the default Measurement Range mode for the analyzer. In this mode, both
analog outputs (A1 and A2) are set to the same range. This Measurement Range
can be set to any value between 0.1 ppb and 10,000 ppb and is accessed through
the following keystroke sequence.
While both A1 and A2 are reporting the same data within the same Measurement
Range span, their respective electronic signal levels can still be configured
differently (see Section 6.6) to meet the input requirements of different recording
devices.
74
Only one of the Range Types described above may be
active at any time.
RANGE = 500.0 PPB
RNGE PASS CLK MORE
RANGE CONTROL MENU
SET UNIT
RANGE MODE:
Go To
Section
6.5.3 6.5.4
NOTE
O3 =XXX.X
SETUP
EXIT
EXIT
SNGL
ENTR EXIT
Go To
Section
6.5.5
Model 400E Ozone Analyzer
Instruction Manual
EXIT Returns
to the Main
SAMPLE Display
P/N 04316 Rev: B