Table of Contents
Advertisement
Snapshot Operations
Recalling a snapshot
To recall a snapshot using the numeric keypad section, use the following
procedure.
1
2
3
4
5
7-8
Chapter 7 Snapshots
Press the SNAPSHOT button, turning it on.
Select the sub-register or sub-registers, using the sub-register selection
buttons.
For details, see step 3 in the previous section "Saving a snapshot" (page
7-6).
Press the RCALL button, turning it on.
The display shows the number of the register which you recalled last
time.
Use the numeric keypad to enter the register number from which you
want to recall the snapshot.
The display shows the legend "Rcall" followed by the register number
you have entered.
If the sub-registers of the snapshot selected in step 2 have attributes
applied, the corresponding attribute selection buttons light. For example,
if the M/E-1 sub-register of the snapshot has the "AUTO TRANSITION"
attribute, and the M/E-2 sub-register has the "XPT DISABLE" attribute,
the CLR/AUTO TRANS button and TRIM/XPT DSBL buttons light
simultaneously.
To apply attributes, press the required combination of the attribute
buttons, turning them on.
To remove an attribute which is already applied, press the corresponding
attribute selection button, turning it off.
The correspondence between buttons and attributes is as follows:
+/–/EFF DIS button: "EFFECT DISSOLVE" attribute
CLR/AUTO TRANS button: "AUTO TRANSITION" attribute
TRIM/XPT DSBL button: "XPT DISABLE" attribute
Advertisement
Table of Contents
