Snapshot Recalling; Recalling A Snapshot By Entering The Register Number; Recalling A Snapshot By Direct Recall - Sony HDS-7100 User Manual

Snapshot Recalling

Recalling a Snapshot by Entering the Register Number

Use the following procedure.
1
2
3
4

Recalling a Snapshot by Direct Recall

The direct recall function is a short-cut which you can take when the register
to be recalled only differs from the currently displayed register number in the
unit's column value.
For example, if the currently displayed register number is 1, and you wish to
recall register 2, use the following procedure.
1
2
8-4
Chapter 8 Snapshot
Press the RECALL button, turning it on.
With the DIRECT button off, enter the number of the register (1 to 99)
from which you wish to recall the snapshot.
The numeric display shows the selected register number. If the snapshot
in this register has attributes set, the corresponding buttons in the
numeric keypad light.
To recall the snapshot with some of the attributes changed, press the
corresponding button or buttons.
Press the ENTER button.
This recalls the snapshot from the specified register, restoring the system
to the state when the snapshot was saved. This only affects settings
relating to the signals, however, and does not change the currently
displayed menu, for example.
With the RECALL button lit, press the DIRECT button, turning it on.
The system is now in the direct recall mode.
Press the button for the unit's column value of the register number (in
this case 2).
This recalls the snapshot from the specified register. If the snapshot in
this register has attributes set, the corresponding buttons in the numeric
keypad light.