Samsung WEC8500 Operation Manual page 362

WEC8050 / WEC8500 Operation Manual
7.16 Station-based Adaptive Load Balancing
Station-based Adaptive Load Balancing performs load balancing based on the number of
stations and RSSI in an individual radio unit of the AP group. Configuring Basic Function
and Setting Load Balancing Parameters of AP Group are available and the settings of the
load balancing parameters in individual APs are available to apply a different value set only
for a specific AP.
7.16.1 Basic Setting of Station-based Adaptive Load Balancing
Station-based Adaptive Load Balancing operates only when it is enabled in the setting of
the basic functions and configures options applied to the overall function operation.
Configuration using CLI
To configure the basic function, execute the commands as follows:
1) Go to the configure  load-balancing configuration mode of CLI.
APC# configure terminal
APC/configure# load-balancing
APC/configure/load-balancing#
2) Activate the Station-based Adaptive Load Balancing function.

enable
3) If a function of distributing stations uniformly among APs is necessary, activate the
Active Load Balancing function (Default: no active).

active
4) To activate the Active Load Balancing function, set up the interval for attempting to
distribute uniformly.

interval [NUMBER]
Parameter
NUMBER
5) To allow load balancing among APs which use the same channel, set the following
option (Default: no allow-channel):

allow-channel
© Samsung Electronics America
Description
Interval for performing active load balancing (sec)
Version 7.1
page 362 of 673