Samsung WEC8500 Operation Manual page 331

WEC8050 / WEC8500 Operation Manual
Starting Service
You must start the remote packet capture service to connect to a device using a program
that supports the remote packet capture protocol on a remote PC.
The related commands are given below.
APC/configure/pcap# start-service
Retrieving Configuration Information
Use the 'show pcap current-config' command to retrieve the remote packet capture
configuration information.
APC# show pcap current-config detail
- Current status : Idle
- Filtering mode : station-only
- Configured AP's MAC Information
No.
Inbound Rate
===== ===================== =========== =============================
================ ================
1 F4:D9:FB:23:66:00
0.0
ID
------ ----------- ----------------------- ---------------
2
- Configured Station's MAC Information
No.
Inbound Rate
===== ===================== =========== =============================
================ ================
1 78:47:1D:C5:4C:85
0.0
2 FC:A1:3E:47:59:E7
0.0
WEC8500#
© Samsung Electronics America
MAC Addr. Filtering
Outbound Rate
--------> ON
0.0
Prf.
ap_2 AP_f4d9fb236600
MAC Addr. Filtering
Outbound Rate
OFF <-------
0.0
AP WN
---- ---- --------------------------- ---------------
2 2 Ajay_2_2_4G
OFF <-------
0.0
AP WN
---- ---- --------------------------- ---------------
2 2 Ajay_2_2_4G
Matched Count
0
AP Name
Matched Count
0
SSID
0
SSID
Version 7.1
IPv4 Addr
10.10.10.20
IPv4 Addr
20.20.20.30
IPv4 Addr
20.20.20.25
page 331 of 673