Acl-Profile - Samsung WEC8500 Operation Manual

WEC8050 / WEC8500 Operation Manual
4.2.2.3 Role-based Access Control Configuration of Remote AP Group
Explanation on the configuration of the role based access control of the remote AP group is
separately made in the "Role Based Access Control" chapter.
4.2.2.4 Configuring Tunneling Forwarding of Remote AP Group
Possible to configure the split ACL to a WLAN set with tunneling among WLANs included
in the remote AP group.
Configuration using CLI
To configure the split ACL of the remote AP group, perform the command as follows:
1) Go to configure  Remote AP Group configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure#
WEC8500/configure/ap-group [remote-ap-group-name]
WEC8500/configure/ap-group/[remote-ap-group-name]#remote
2) Designate the split ACL in the WLAN set with the tunneling mode.

tunneling-forwarding [WLAN-ID] [SPLIT-ACL-NAME]
3) Execute the 'show ap-group remote-forwarding [REMOTE AP GROUP NAME] '
command to check the AP group information.
4) Use the 'send-remote-acl-to-ap profile-only' command to send the ACL Profile
information of the remote AP group to APs.
5) Use the 'send-remote-acl-to-ap all' command to send the information on the ACL
Profile, Tunneling Forwarding and Local Bridging Forwarding of the remote AP group
to APs.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<AP Groups> menu in the sub-menus. After selecting the name of the remote AP group,
you can configure Tunneling Forwarding in the "ACL Profile" item of the 'Remote AP
Group' tab. In addition, you can click the "Send To APs" button to send the information on
ACL Profile, Tunnel Forwarding, and Local Bridging Forwarding to APs.
© Samsung Electronics America
Version 7.1
page 184 of 673