Samsung WEC8500 Operation Manual page 54

WEC8050 / WEC8500 Operation Manual
The port related CLI commands are as follows:
[auto-nego, speed, duplex]
The commands used to configure an auto-nego, speed, and duplex addresses are shown
below. To delete the configuration, enter the 'no' parameter.
WEC8500/configure/interface ge1# speed-duplex ?
10-full
10-half
100-full
100-half
1000-full
1000-half
auto-nego
[admin status]
This is a command that makes the port not working. The 'no' parameter is used to restart
the port.
shutduown
no shutdown
[flow control]
This is a command that operates flow control to the port. The 'no' parameter is used to stop
the flow control.
flowcontrol on
no flowcontrol on
[switch port]
This is a command that changes the port to the L2 mode. The 'no' parameter is used to
change it to the L3 mode.
switchport
no switchport
[ip address]
This is a command that configures a static IP address. To delete the configuration, enter the
'no' parameter.

ip address {A.B.C.D/mask length}

no ip address {A.B.C.D} {A.B.C.D}

no ip address {A.B.C.D/mask length}
© Samsung Electronics America
Set 10Mb/s full-duplex
Set 10Mb/s half-duplex
Set 100Mb/s full-duplex
Set 100Mb/s half-duplex
Set 1000Mb/s full-duplex
Set 1000Mb/s half-duplex
Set auto negotiation speed/duplex
Version 7.1
page 54 of 673