Samsung WEC8500 Operation Manual page 296

WEC8050 / WEC8500 Operation Manual
[AirMove Enable/Disable Configuration]
The AirMove is enabled by default, so use the following command to disable it.

no handover mode NCHO
To check the configuration information, use the 'show handover configuration' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Mobility Management>  <Handover> menu in the sub-menus.
You can enable or disable the intra handover function by selecting Enable/Disable in the
INTER APC HAND-OVER item. After configuring a value, click the <Apply> button to apply.
7.2.3 Inter APC Handover Configuration
The Inter APC handover is a technology that supports handover among several APC
systems. Depending on network configuration, the Inter APC L3 handover and Inter APC
L2 handover services are provided.
By using the clustering service, you can configure several APC systems into a single group.
Configures whether to use the Inter APC handover.
The default value of Inter APC handover is not configured.

handover inter-apc enable
To check the configuration information, use the 'show handover configuration' command.
© Samsung Electronics America
Figure 157. Handover window
Version 7.1
page 296 of 673