Samsung WEC8500 Operation Manual page 420

WEC8050 / WEC8500 Operation Manual
[SNAT Configuration using Static IP]
To add SNAT using a static IP, execute the command as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Configure a NAT to the interface.
WEC8500/configure# interface vlan1.30
WEC8500/configure/interface vlan1.30#ip nat outside
WEC8500/configure/interface vlan1.30#exit
3) Configure a NAT rule using a static IP.
WEC8500/configure# ip nat outside source static 10.10.10.10 30.30.30.1
[DNAT Configuration using Access List]
To add Destination NAT (DNAT) using an access-list, execute the command as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Create a NAT pool.
WEC8500/configure# ip nat pool pool2 10.10.10.10 10.10.10.10
255.255.255.0
3) Configure a NAT to the interface.
WEC8500/configure# interface vlan1.30
WEC8500/configure/interface vlan1.30#ip nat outside
WEC8500/configure/interface vlan1.30#exit
4) Add the NAT rule by using access-list and pool.
WEC8500/configure# ip nat outside destination list fw6 pool pool2
© Samsung Electronics America
Version 7.1
page 420 of 673