Samsung WEC8500 Operation Manual page 157

WEC8050 / WEC8500 Operation Manual
4) To check the configured apc list, execute the 'show apc summary' command.
5) To check the redundancy information, execute the 'show redundancy summary'
command.
6) To check the configured AP profile, execute the 'show ap detail [AP_PROFILE_
NAME]' command.
Configuration using Web UI
By referring to the 'APC List Management', add the APC list that will be used as a backup
APC.
1) In the menu bar of <WEC Main window>, select <Configuration> and then select
the <Controller>  <Redundancy> menu in the sub-menus. Operator can add or
delete the APC list that will be used for redundancy. If necessary, operator can
configure the fallback function.
Parameter
APC NAME
MAC ADDRESS
IP_ADDRESS
PORT
© Samsung Electronics America
Figure 72. Redundancy Configuration Window
Name of an APC to be added or deleted to/from redundancy
The APC must be an APC registered in the APC list.
Because this is a MAC address configured during registration to the APC list,
an operator does not have to enter this at the redundancy
configuration stage.
IP address of an APC to add
This address is an IP required by an AP to connect to the APC.
Therefore, you must enter the AP Management IP address of the APC.
CAPWAP PORT number of the APC to add
If no port number is entered, it is set to 5246, the default port number of
Description
Version 7.1
page 157 of 673