Samsung WEC8500 Operation Manual page 96

WEC8050 / WEC8500 Operation Manual
3) Virtual-Link configuration
Configuration using CLI
WEC8500/configure/router/ospf 1# area 2 ?
authentication
default-cost
or stub area
filter-list
nssa
range
(border routers only)
shortcut
stub
virtual-link
WEC8500/configure/router/ospf 1# area 2 virtual-link ?
A.B.C.D
link neighbor
WEC8500/configure/router/ospf 1# area 2 virtual-link 10.10.10.1 ?
authentication
authentication-key
dead-interval
hello-interval
message-digest-key
retransmit-interval
transmit-delay
<cr>
To configure the Virtual-Link, enter an ID (router ID of OSPF that is connected via Virtual)
and configure the detail items. The detail items include authentication, authentication-key,
dead-interval, hello-interval, message-digest-key, retransmit-interval, or transmit-delay, etc.
Authentication configuration
Operator can configure authentication and message-digest.
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1
authentication ?
message-digest
<cr>
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1
authentication message-digest ?
<cr>
WEC8500/configure/router/ospf 2# area 2 virtual-link 10.10.10.1
authentication message-digest
Authentication-key configuration
Enter 8-character word to be used as an authentication key. Use the entered 8-character as
an authentication key.
© Samsung Electronics America
Enable authentication
Set the summary-default cost of a NSSA
Filter networks between OSPF areas
Specify a NSSA area
Summarize routes matching address/mask
Configure the area's shortcutting mode
Configure OSPF area as stub
Define a virtual link and its parameters
ID (IP addr) associated with virtual
Enable authentication
Set authentication key
Dead router detection time
Hello packet interval
Set message digest key
LSA retransmit interval
LSA transmission delay
Use message-digest authentication
Version 7.1
page 96 of 673