Samsung WEC8500 Operation Manual page 258

WEC8050 / WEC8500 Operation Manual
5.4.3 DHCP Proxy
The procedure of changing to the DHCP proxy is as follows.
Configuration using CLI
The CLI configuring a DHCP proxy is located as a command under 'ip dhcp-proxy' in the
configure mode.
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Switch to the DHCP proxy.
WEC8500/configure#ip dhcp-proxy enable
3) To check the configured information, use the 'show ip dhcp-proxy' command.
4) Use the below command to check an IP address that is leased through the DHCP
proxy.
WEC8500t#show ip dhcp proxy-lease
IP address
10.10.10.100
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<DHCP>  <Proxy> menu in the sub-menus.
You can configure the Proxy mode of DHCP to relay/proxy. Change the radio box for
configuration in the DHCP PROXY MODE of Global Parameter item.
© Samsung Electronics America
| Server IP |
1.1.1.1 00:1c:bf:c1:50:28
Figure 131. DHCP Proxy
MAC address | Lease Expiration time
2012/08/31 12:00:24
Version 7.1
page 258 of 673