Samsung WEC8500 Operation Manual page 173

WEC8050 / WEC8500 Operation Manual
Parameter
RETRANSMIT-INTERVAL
MAX-ECHO-RETRANSMIT
OVERWRITE-TELNET-SSH
TELNET-ENABLE
SSH-ENABLE
OVERWRITE-CONSOLE
CONSOLE-ENABLE
OVERWRITE-DTLS
DTLS-POLICY
OVERWRITE-LED-CONTROL
LED-CONFIG
OVERWRITE-VLAN
VLAN-SUPPORT
NATIVE-VLANID
OVERWRITE-POE-TYPE
POE-TYPE
OVERWRITE-UPLINK-
BANDWIDTH
UPLINK-BANDWIDTH
© Samsung Electronics America
information provided by the CAPWAP (unit: seconds).
The APC waits for this length of time before retransmitting an
echo request message when there is no response. The APC sets
double the length of echo-interval as the echo timeout time. If no
echo message is received from the AP for as long as double the
length of the echo-interval, the APC judges that the AP is down
(unit: seconds).
The APC waits for this length of time before retransmitting an
echo request message when there is no response. The APC sets
double the length of echo-interval as the echo timeout time. If no
echo message is received from the AP for as long as double the
length of the echo-interval, the APC judges that the AP is down
(unit: seconds).
If overwrite-telnet-ssh is enabled, the telnet and SSH settings for
the AP group are applied to all APs within the group.
This enables the telnet server and configures telnet port of the
AP.
This enables the SSH server and configures SSH port of the AP.
If overwrite-console is enabled, the telnet and SSH settings of
the AP group are applied to all APs within the group.
This configures whether to allow console access to the AP.
If overwrite-dtls is enabled, the DTLS settings of the AP group
are applied to all APs within the group.
Configures the DTLS Policy of an AP.
If overwrite-led-control is enabled, the LED settings of the AP
group are applied to all APs within the group.
This configures whether to turn the LED on/off.
If overwrite-vlan is enabled, the VLAN settings of the AP group
are applied to all APs within the group.
This configures whether to enable the native VLAN of the AP.
This configures the native VLAN value of the AP.
If the overwrite-poe-type is activated, the POE Type information
set in the AP group is applied to all APs in the group.
Sets the POE Type information below.
802.3at/802.3af/auto
If the overwrite-uplink-bandwidth is activated, the uplink
bandwidth information set in the AP group is applied to all APs in
the group.
Sets the allowed value for AP uplink bandwidth.
Possible to set between 1 and 1024 Mbps and if it is set to 0, the
uplink bandwidth is not restricted.
Description
Version 7.1
page 173 of 673