Samsung WEC8500 Operation Manual page 226

WEC8050 / WEC8500 Operation Manual
Configuration using CLI
1) Go to configure  apc configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc#
2) Enable or disable the repeater service. The repeater service must be enabled for the
repeater AP to connect to the root AP.

repeater-service: Enabled

no repeater-service: Disabled
3) Use the 'show wlan detail repeater' command to check the root WLAN settings.
WEC8500/configure/apc# show wlan detail repeater
[Changing to Root AP]
The procedure of changing a Wireless Enterprise AP to a Root AP is as follows:
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Check the registered AP list.
WEC8500/configure# show ap summary
3) Go to AP configuration mode to change to a Root AP.
WEC8500/configure# ap ap_1
4) Configure it to a Root AP.
WEC8500/ configure/ap ap_1# profile ap-mode rootAp
5) Restart the configured AP.
© Samsung Electronics America
Version 7.1
page 226 of 673