Figure 5. Management Port Configuration - Samsung WEC8500 Operation Manual

WEC8050 / WEC8500 Operation Manual
LED
2)
Console port (RS232C)
A console port is used to check the operational status of WEC8500 or for input through the
CLI. Its basic requirements are as follows:

Baud rate: 115200 bps

Character size: 8 characters

Parity: None

Stop bit: 1, Data bit: 8

Flow control: None
Management port (1 GE UTP)
The WEC8500 provides a 10/100/1000BASE-T port (RJ-45) for management purpose.
It is working in 10/100 Mbps half duplex/full duplex mode or in 1000 Mbps full duplex
mode. Because it supports the automatic MDI/MDI-X function, you can use a straight-
through cable for all the network connections to a PC, server, switch, or network hub.
Configuration item
LED
Connector
When connecting a cable to the management port, make sure to check if the cable complies
with the 10 BASE-T, 100 BASE-TX, or 1000 BASE-T.

Cable type: UTP or STP cable using RJ-45 connector
 10 BASE-T: Category 3 or higher
 100 BASE-TX: Category 5 or higher
 1000 BASE-T: Category 5 or higher (Category 5e or higher is recommended)

Isolate from wireless frequency disturbing waves

Shut down electrical surge
© Samsung Electronics America
Status
Red Power is turned off or a fault occurred while the power
module 2 is installed.
Off Power module 2 is not installed.

Figure 5. Management Port Configuration

Status
Green Turned on for link connection
Orange Blinking for data exchange
- Connector for UTP cable connection
Description
LED
Connector
Description
Version 7.1
page 28 of 673