Samsung WEC8500 Operation Manual page 308

WEC8050 / WEC8500 Operation Manual
8) Execute the following command to set the anchor time. The default value is start time
4, end time 5. If both start time and end time are set to the same time, Anchor Run
function is disabled.
WEC8500/configure/rrm/80211a/dcs# anchor-time start [value] end [value]
9) Execute the following command to change the channels that is automatically set by the
DCS. Use the 'no' parameter to disable the mode.
WEC8500/configure/rrm/80211a/dcs# channel [value]
10) Execute the following command to use the Delayed Channel Change function.
To disable the configuration, enter the 'no' parameter. The default is Disable.
The Delayed Channel Change function delays channel change instead of changing it
immediately when a channel becomes busy due to channel utilization. If the anchor
time is not configured, the default value is used at 4 o'clock.
WEC8500/configure/rrm/80211a/dcs# delayed-channel-change
11) To use the Aware Option function, execute the following command. To disable the
configuration, enter the 'no' parameter. The Aware Option does not change a channel if
there is a specific condition. Therefore, three functions are provided based on whether
there is a voice, the association of a station, or traffic in a station. The default is that
only the Voice Aware function is enabled. The Station Aware function specifies the
number of stations at the same time.
WEC8500/configure/rrm/80211a/dcs# aware-option voice
WEC8500/configure/rrm/80211a/dcs# aware-option station [station count]
WEC8500/configure/rrm/80211a/dcs# aware-option traffic
12) Check the settings using the 'show rrm config-summary' command.
© Samsung Electronics America
Version 7.1
page 308 of 673