WEC8050 / WEC8500 Operation Manual
Configuration using CLI
The procedures for configuration are as follows.
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure# apc
WEC8500/configure/apc/apc-list#
2) Go to the apc-list item of CLI.
WEC8500/configure# apc
WEC8500/configure/apc/apc-list#
3) Add, delete or change APC.
add-apc [APC_NAME] [MAC_ADDRESS]
del-apc [APC_NAME]
change-apc [CURRENT_APC_NAME] [NEW_APC_NAME]
change-mac [APC_NAME] [MAC_ADDRESS]
Parameter
APC_NAME
CURRENT_APC_NAME
NEW_APC_NAME
IP_ADDRESS
4) To check the configured APC list, execute the 'show apc-list' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <APC Lists> menu in the sub-menus. Operator can add a new APC by
clicking the <Add> button in the figure.
© Samsung Electronics America
APC name
Current APC name (before change)
APC name after change
APC MAC address (xx:xx:xx:xx:xx:xx)
In the APC system, enter the system mac address output parameter
value of 'show system info' command.)
Figure 69. APC List Management Window
Description
Version 7.1
page 149 of 673