Samsung WEC8500 Operation Manual page 64

WEC8050 / WEC8500 Operation Manual
3.3.2 Bridge
To set up bridge related functions, go to configure mode by executing the following
command
WEC8500# configure terminal
The bridge related commands are as follows:
[bridge address]
This command configures a bridge address. The 'no' parameter is used to clear the
configuration.

bridge 1 address [MAC] [forward/discard] [IFNAME]

no bridge 1 address [MAC] [forward/discard] [IFNAME]
Parameter
MAC
forward/discard
IFNAME
[bridge ageing time]
This command configures the age-out time of a bridge. The 'no' parameter is used to clear
the configuration.

bridge-group 1 ageing-time [AGEINGTIME]

no bridge-group 1 ageing-time
Parameter
AGEINGTIME
[bridge protocol]
This command creates a bridge in one of the IEEE 802.1Q Spanning-Tree Protocol (STP),
IEEE802.1s multiple STP (MSTP), or IEEE 802.1W Rapid STP (RSTP) protocol.

bridge 1 protocol [PROTOCOL]

no bridge 1 protocol
Parameter
PROTOCOL
© Samsung Electronics America
MAC address. Entered in the format of HHHH.HHHH.HHHH.
- forward: Configures forward matching frame.
- discard: Configures discard matching frame.
Interface name of a bridge.
age-out time (range: 10-1000000 s)
Protocol to configure (ieee/mstp/rstp)
- ieee: STP
- mstp: MSTP
Description
Description
Description
Version 7.1
page 64 of 673