Samsung WEC8500 Operation Manual page 124

WEC8050 / WEC8500 Operation Manual
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security>  <Access Control Lists>  <IP ACL> menu in the sub-menus.
To change the configuration of ACL rule, click ACLNAME to change. You can change the
configuration using the <Add> or <Delete> button. In addition, if there is a time profile in
an ACL name, the IP ACL window is changed as shown below. After selecting a time
profile, click the <Apply> button to apply the time profile to the ACL.
3.5.5.3 ACL (Time-Profile) Rule Configuration
Configuration using CLI
1) Go to configure  interface configuration mode of CLI.
APC# configure terminal
APC/configure# interface ge2
2) Configure ACL to the interface. The 'no' parameter is used to delete ACL.

ip access-group [MODE] [DIRECTION] [ACL_NAME]

no ip access-group [fw/fqm] [DIRECTION] [ACL_NAME]
Parameter
MODE
DIRECTION
ACL_NAME
3) To check the configuration information, use the 'show running-config network' command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security>  <Access Control Lists>  <Access Group (Interface)> menu in the sub-
menus.
Perform configuration by referring to 'ACL Rule Configuration'.
© Samsung Electronics America
Figure 45. Applying to ACL
Configuration mode (fw/fqm)
For ACL rule configuration, select 'fqm' (The 'fw' is used for firewall configuration.)
Application direction configuration (in/out)
ACL name to configure
Description
Version 7.1
page 124 of 673