Samsung WEC8500 Operation Manual page 330

WEC8050 / WEC8500 Operation Manual
7.8 Remote Packet Capture
APC can capture a packet exchanged between the wireless terminals on a remote PC in
real-time by using the remote packet capture protocol.
To configure the remote packet capture function, you must go to the pcap mode by
executing the command as follows:
APC# configure terminal
APC/configure# pcap
Configuring the MAC address of a wireless terminal
Configure the MAC address of a wireless terminal whose packets will be captured.
APC/configure/pcap# config-filter
APC/configure/pcap/config-filter# station-mac [MAC_ADDRESS]
APC/configure/pcap/config-filter# enable-station-mac [INDEX]
Parameter
MAC_ADDRESS
INDEX
Configuring AP MAC address
Configure the MAC address of an AP whose packets will be captured.
APC/configure/pcap# config-filter
APC/configure/pcap/config-filter# ap-mac [MAC_ADDRESS]
APC/configure/pcap/config-filter# enable-ap-mac [INDEX]
Parameter
MAC_ADDRESS
INDEX
Configuring Filtering Mode
Capture target can be specified by configuring the filtering mode
APC/configure/pcap# filtering-mode [FILTERING MODE]
Parameter
FILTERING MODE
© Samsung Electronics America
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
MAC address (11:22:33:44:55:66 format)
Index number of MAC address (range: 1-10)
Filtering mode
- station-only: Use only the configured station MAC information.
- ap-only: Use only the configured AP MAC information.
Description
Description
Description
Version 7.1
page 330 of 673