Samsung WEC8500 Operation Manual page 176

WEC8050 / WEC8500 Operation Manual
5) Use the 'show airmove group [ap_group_name]' command to check the AP group
information.
WEC8500# show airmove group default
Airmove Group Configurations
----------------------------
Airmove State
Target AP
Scan trigger level
Scanning time for one channel
Service time during scanning
Scanning interval time
Number of probe requests
Number of scanning channels
Value of station roam delta
WEC8500#
Configuring SSL (Smart Service Link) of AP Group with CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.
ap-group[AP_GROUP_NAME]
3) Enter the profile configuration mode for the AP group.
profile
4) Configure the SSL function for the AP group.

enable: Enables/disables the SSL function.

target-ap: This option is used for selecting APs that will have the changes applied to
the group settings. If 'all' is selected, changes are applied to all APs and the config
priority of the APs also change to group. If 'keep-ap-config' is selected, only the APs
whose config priority is set to group have the SSL value of the group applied to
them.
WEC8500# configure terminal
WEC8500/configure# ap-group default
GroupName : default
WEC8500/configure/ap-group default# sta-ssl
WEC8500/configure/ap-group default/sta-ssl# ?
decision-delta
enable
© Samsung Electronics America
Disable
Keep Ap Config
-70 dBm
5 ms
100 ms
1000 ms
2
4
15
Set delta value for handover decision
sta-ssl enable
Version 7.1
page 176 of 673