Samsung WEC8500 Operation Manual page 163

WEC8050 / WEC8500 Operation Manual

overwrite-ip-mode

no overwrite-ip-mode

ip-mode

overwrite-state

no overwrite-state

shutdown

no shutdown

no overwrite-redundancy

discovery

primary-apc

no primary-apc

secondary-apc

no secondary-apc

tertiary-apc

no tertiary-apc
Parameter
DESCRIPTION
OVERWRITE-AP-
MODE
AP-MODE
OVERWRITE-
LOCATION
LOCATION
OVERWRITE-IP-MODE
IP-MODE
OVERWRITE-STATE
shutdown
OVERWRITE-
REDUNDANCY
DISCOVERY
© Samsung Electronics America
This contains a brief description of the AP group.
If overwrite-ap-mode is enabled, the AP mode information set for the
group is applied to all APs within the group.
This is the AP operation mode. The following modes are available:
- generalAp: General operation mode. Default value.
- rootAp: AP mode where a repeater AP can be connected.
- repeasterAp: AP mode that is connected to a wireless area and the
APC through the root AP.
If overwrite-location is enabled, the location information set for the
group is applied to all APs within the group.
This is the location information of the AP.
If overwrite-ip is enabled, the IP mode information set for the group is
applied to all APs within the group.
This is the mode of receiving an IP address by the AP. The following
modes are available:
- dhcp: The AP receives IP address allocation using DHCP.
- ap: The AP uses a manually configured IP address.
If overwrite-state is enabled, the AP state information set for the group
is applied to all APs within the group.
This sets the AP state to UP or DOWN.
If overwrite-redundancy is enabled, the redundancy setting (primary-
apc, secondary-apc, tertiary-apc) of the AP group is applied to all APs
within the group.
If the APCs are configured for redundancy, this configures the method
used for APs to connect to the APC. The following modes are available:
- ap-followed: The discovery type and discovery list configured for the
Description
Version 7.1
page 163 of 673