Samsung WEC8500 Operation Manual page 181

WEC8050 / WEC8500 Operation Manual
4.2.2 Configuring Remote AP Group
If the APs are located in an area where the APC is not located, those APs must be classified
into a separate group for service. The APC can manage the APs in another area by grouping
them into a remote AP group.
In the Remote AP group, the operator can configure the below information and the APs in
the Remote AP group are operating based on the same configuration.

Addition/Deletion of Remote AP
 Possible to add or delete APs to be included in the remote AP group.

Local Authentication
 Radius Server
Possible to set a Radius server which will authenticate a station connecting to the
remote AP.
 Remote AP User List
Possible to add or delete a user (station) to be managed in the remote AP.

Role Based Access Control
 Possible to apply the ACL profile.

Tunnel Forwarding
 Possible to add the split tunnel ACL settings of the WLAN set with the tunneling
mode.

Local Bridging Forwarding
 Possible to add settings of VLAN ID, ACL, and Pre-Auth ACL of the WLAN set
with the local bridging mode.
When an AP group is added and the remote AP group is checked, APs included in the AP
group operates in the remote AP mode.
If an AP is added to or deleted from a remote AP group, the AP is rebooted and reconnected
to the APC. If an AP moves between remote AP groups, the AP is not rebooted.
4.2.2.1 Addition/Removal Setting
Configuration using CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group.

ap-group[REMOTE_AP_GROUP_NAME]
© Samsung Electronics America
Version 7.1
page 181 of 673