Samsung WEC8500 Operation Manual page 192

WEC8050 / WEC8500 Operation Manual

ssh-enable: Configures whether to enable the SSH server of an AP.

static-ip [IP_ADDRESS] [NETMASK] [GATEWAY]: Configures the static IP
address of an AP.

statistics-timer [TIMER]: Configures the time interval of transmitting the statistics
information provided by CAPWAP (unit: seconds)

telnet-enable: Configures whether to enable the telnet server of an AP.

time-config: Configure the timezone per AP.

vlan-support: Configures whether to enable the native VLAN of an AP.

poe-type: Set the POE Type of the AP. You can set 802.3at, 802.3af, and auto.

uplink-bandwidth: Set the allowed value for AP uplink bandwidth. Possible to set
between 1 and 1024 Mbps and if it is set to 0, the uplink bandwidth is not restricted.

temperature-alarm-on-level: If the temperature of the AP exceeds the Temperature-
Alarm-On-Level, the temperature alarm occurs. The default is 98 and possible to set
between 50 and 130.

temperature-alarm-off-level: If the temperature of the AP is less than the
Temperature-Alarm-Off-Level, the temperature alarm is cleared. The default is 98
and possible to set between 50 and 130.

temperature-alarm-control-type: If the temperature alarm occurs, set whether the
radio of the AP is set to be off or on. link-aggregation: In case of an AP model for
802.11ac, provide two uplink Ethernet ports. Possible to set link aggregation for two
Ethernet ports. If the link aggregation is activated, Both (Destination + Source),
Destination, and Source modes are configurable.

Link-aggregation: The 11ac AP model provides 2 uplink Ethernet ports. The 2
Ethernet ports can be configured for link aggregation. If link aggregation is enabled,
the following modes can be configured.

Both (Destination + Source)

Destination

Source
3) To check the information of a configured AP profile, use the 'show ap detail
[AP_NAME]' command.
Configuring IPSec with CLI
Execute the following command to configure IPSec for the AP.
1) In the CLI, go to configure  AP configuration  AP ip-sec mode.
WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1# ip-sec
WEC8500/configure/ap ap_1/ip-sec#
2) Configure ip-sec for the AP using the commands below.

enable
© Samsung Electronics America
Version 7.1
page 192 of 673