Samsung WEC8500 Operation Manual page 483

WEC8050 / WEC8500 Operation Manual
Installation
Only two activation keys can be installed/registered in an APC system.
If two unexpired activation keys co-exist, available services are offered as shown
in the following example:
(Example)
- Activation Key 1: AP (100 units), VQM (Disable), Firewall (Disable)
- Activation Key 2: AP (50 units), VQM (Enable), Firewall (Disable)
- result: AP (100 units), VQM (Enable), Firewall (Disable)
Period of Use
Each activation key has its own information regarding the start and end times,
and if the current time is not within the set period, the activation key expires.
Application
An activation key only functions correctly after the system is rebooted after
deletion or installation of a key.
Configuration using CLI
To configure an activation key, first execute the following commands and enter license mode:
WEC8500# configure terminal
WEC8500/configure# system license
WEC8500/configure/system/license#
[Installing Activation Key]
When the system is shipped out, there is no registered license key. Therefore, you must
install the license key you received immediately after the first system installation. You can
install a license key directly or remotely using CLI.

activate-key [Fullpath filename]
Registers an activation key file. If a license key file exists in a specified folder, use the
license key file for registration.
When entering the file name of an activation key, you must enter the file name
including its full path.
[Clearing Activation Key]
no activate-key [the activation key's license key]

Clears an activation key registered in the system.
You can view the license key information of an activation key in the 'License' field of
the activation key by executing the 'show system license-key' command.
After clearance, you can view information about the deactivation key in the 'License
Key' of the key after executing the 'show system license-key' command.
© Samsung Electronics America
Version 7.1
page 483 of 673