WEC8050 / WEC8500 Operation Manual
8.2.4.1
Configuring Manual Blocking
To configure manual blocking, execute the command as follows:
Configuration using CLI
1) Go to configure wids containment configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wids
WEC8500/configure/wids# containment
WEC8500/configure/wids/containment#
2) Configure manual blocking.
manual[TARGET] enable[MAC]
Parameter
TARGET
MAC
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Monitor> and then select <Wireless
Intrusion> menu in the sub-menus.
Select the target and perform containment to perform manual blocking.
1) After selecting an AP in the AP list, possible to block by using the containment.
© Samsung Electronics America
Select either AP or station which is the target for manual blocking.
MAC address of the target for manual blocking
Figure 204. List Window for Blocking AP
Description
Version 7.1
page 399 of 673