Samsung WEC8500 Operation Manual page 43

WEC8050 / WEC8500 Operation Manual
2.1.3 APC Management Port Configuration
To connect to the APC remotely using telnet/SSH or web, it is necessary to set up an IP
address to the management port.
Set up the management port as follows:
1) Go to configure  'mgmt0' interface configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
2) Set up an IP address.
WEC8500/configure/interface mgmt0# ip address 100.100.100.1/24
2.1.4 SNMP Community Configuration
To connect to the web server of APC, it is necessary to add Simple Network Management
Protocol (SNMP) community through CLI. For more information, see '10.1 SNMP
Configuration'.
2.1.5 CLI Basic Usage
The CLI is a text command based interface used to change or retrieve the system settings.
Several users can change the settings at the same time using the CLI of the same system.
Because privilege per user is already configured, a user can execute a command allowed by
the user's privilege. Various commands are available for each system function. For more
information, see ANNEX 'CLI Command Structure'.
Command Help
The CLI provides a help for all the commands. To see a help for a command and parameter,
enter '?'. Based on an input character, it shows a help for a command or parameter that can
be entered.
Category
?
Command ?
© Samsung Electronics America
Displays the command list and help at the current level
Displays the parameter and help required for a command
Description
Version 7.1
page 43 of 673