Samsung WEC8500 Operation Manual page 443

WEC8050 / WEC8500 Operation Manual
8.8 External BYOD Server
The Wireless Enterprise WLAN system provides a function of interoperating with the
external BYOD server. To use the BYOD function, a separate BYOD server is necessary.
Employees and guest users can receive a service after being connected to a specific WLAN
(SSID) and going through authentication.
(The external BYOD server now supported is only AirCuve BYOD.)
8.8.1 Configuring External BYOD Server
Configuration using CLI
To configure the interoperation with external BYOD, execute the command as follows:
1) Go to configure  security  byod of CLI.
WEC8500# configure terminal
WEC8500/configure# security byod
2) Enter the IP address of the BYOD server.
WEC8500/configure/security/byod# address1 10.10.10.20
To interoperate with AirCuve BYOD Suite, enter Airfront IP in address1 and Byfront
IP in address2.
3) Enable the function of interoperating with the external BYOD server.
WEC8500/configure/security/byod# enable
4) Configure a HTTPS request URL.
Upon the interoperation with AirCuve BYOD Suite, the HTTPS request URL is
necessary to update the list of all authentications. The basically set value is used and if
change is required in the future, change as follows:
WEC8500/configure/security/byod# https-requrl
regist.do?cmd=dhcpTableXMLReceiver
5) To check the configured environment, use the 'show security byod configuration'
command.
© Samsung Electronics America
Version 7.1
page 443 of 673