Samsung WEC8500 Operation Manual page 73

WEC8050 / WEC8500 Operation Manual
3.4.4 PIM Configuration
The procedure for Protocol Independent Multicast (PIM) configuration is given below.
1) Go to configure  interface configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# interface ge2
2) Configure the PIM sparse mode to an interface.
WEC8500/configure/interface ge2# ip pim sparse-mode
3) Check a configured PIM using the 'show running-config network' command.
To check the multicast-routing table, use the 'show ip mroute' command.
WEC8500# show ip mroute
(90.90.1.242, 224.0.1.1)
3.4.5 OSPF Configuration
3.4.5.1 General settings
Configuration using CLI
1) Go to configure  ospf configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# router ospf
WEC8500/configure# router ospf ?
1 - 10
2) Configure the process ID from 1 to 10.
WEC8500/configure# router ospf ?
1 - 10
WEC8500/configure# router ospf 2
WEC8500/configure/router/ospf 2#
Parameter
OSPF process ID
© Samsung Electronics America
Iif: mgmt0
OSPF process ID
OSPF process ID
Description
Configure the process ID from 1 to 10.
Version 7.1
Oifs: pimreg
page 73 of 673