Avaya Cajun P882 User Manual page 209

Automatically
Creating VLANs
and Frame Tags
Parameters
Automatic
Binding of
VLANs to Ports
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
.
Table 5-8. Avaya P550R/P580/P880/P882 Multiservice Switch
Name
Default
Discard
Net90
*autoVlan100
* Automatically created by the switch software
All others created manually
VLANs are created automatically by the switch reading the VLAN
tag of all ingress IEEE 802.1Q and Multi-Layer tagged frames. The
switch then creates a new VLAN for every new VLAN tag identified.
However, if the parameter for 'Frame Tags' is set to "ignore", the
switch will ignore the VLAN tags on ingress frames. The switch
assumes that all ingress frames belong to the 'Port VLAN'.
Therefore, no new VLANs will ever be created automatically.
When a VLAN is either manually or automatically created, the
software may automatically bind the VLAN to a port depending on
the setting of the 'Trunk Mode' parameter assigned to the port.
When a VLAN is created manually the software assigns the
VLAN to all ports whose VLAN Binding is set to Bind to All.
No other ports will automatically be assigned when a VLAN is
created manually.
When a VLAN is created automatically the software assigns the
VLAN to the port it is received on if that port is set to Bind to
All and Bind to Received. Additionally, software will assign the
VLAN to all other ports whose VLAN Binding is set to Bind to
All.
following command from Configure mode:
<configure># set port VLAN <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for more details about this
command.
Configuring Port Parameters
VLAN Table
ID Group ID
1 2
4097 3
90 90
100 100
AFT Index
1
3
7
11
5-31