Parameter
DVMRP Interface
Network Address
Address Mask
State
Type
Metric
IGMP Querier on Interface
Next Probe Message in (sec)
Unrecognized Packets
Received
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Click CLEAR All to reset all statistics to zero.
—
Click CLEAR to reset the selected interface.
—
3. Refer to Table 9-19 for an explanation of the DVMRP
Interface Statistics dialog box parameters:
Table 9-19. DVMRP Interface Statistics Parameters
Defines the...
IP interface configured with the DVMRP multicast
routing protocol.
IP address of the interface configured with the DVMRP
multicast.
IP subnet mask associated with the interface.
Current status of the interface. Possible status indications
include:
• UP - The interface is active.
• DOWN - The interface is inactive.
Type of interface configured. Possible values include:
• Broadcast - All traffic is forwarded through the
routers. This is not a tunnel and does not require
encapsulation.
• IPIP Tunnel - All multicast traffic (data and
protocol messages) on this interface is encapsulated
in IP unicast packets with the protocol set to IPIP (IP
in IP).
• Non-Encapsulated Tunnel - All multicast data
traffic on this interface is IPIP encapsulated, but the
protocol messages are simple unicast.
Interface cost.
Router is the IGMP querier. The purpose of the IGMP
querier is to periodically poll hosts on your network to
trigger group membership reports.
Time (in seconds) remaining until the next probe
message is sent.
Number of unknown DVMRP messages.
Configuring IP Routing
1 of 2
9-79