Avaya Cajun P882 User Manual page 198

Chapter 5
Parameter
Name
Category
Speed Mode
Duplex Mode
Flow Control
Mode
5-20
Table 5-4. Fast Ethernet (10/100) Port Parameters
Definition
Enter a user configurable name for this port (possibly
a drop connection name or the name of the station
or other device connected to the port).
Select either User Port or Service Port.
• The User Port is intended for use with switch
connections to end user nodes.
• The Service Port is intended for use with
switch connections to servers or other switches.
The Service Port allows the switch to generate
both log messages and alarm messages (traps). The
User Port only generates log messages,
preventing your network management station
from being overwhelmed by port up/down
messages that result from users turning
workstations on and off.
Select the speed of the port manually (to either 10 or
100 Mb/s). If auto-negotiation is enabled, this
setting is ignored.
Select the port duplex mode (half- or full-duplex). If
auto-negotiation is enabled, this setting is
ignored.
Determines if flow control is used on this port. For
half-duplex links, active backpressure jams the
sending Ethernet channel until the port's buffers can
receive more packets. This prevents lost or dropped
packets.
For full-duplex links, IEEE 802.3z pause control
allows the port to stop a sending station from sending
more packets if the receiving port's buffers are full.
For TX and FX ports, there is an additional option for
Enable with Aggressive Backoff. This option limits
the size of the bursts.
Flow Control is recommended for use primarily on
end-station connections. Using this flow control on
trunk ports can cause unnecessary congestion on the
network.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
1 of 2