Configuring A Static Route For The Ppp Console - Avaya Cajun P882 User Manual
Multiservice switch
Hide thumbs
Also See for Cajun P882:
- User manual (782 pages) ,
- Command reference manual (764 pages) ,
- Cli reference manual (617 pages)
Table of Contents
Advertisement
Parameter
Last Change
Producer Signal
Consumer Signal
Using the CLI
Configuring a Static Route for the PPP Console
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
3. Refer to Table 9-34 for an explanation of the LDAP
Statistics dialog box parameters:
Table 9-34. LDAP Statistics Dialog Box Parameters
Definition
Displays the sysUpTime since this device was last modified.
You can detect a change in the Policy Capabilities by polling a
single object using this information.
The sequence number that, when modified, triggers the LDAP
client to download the latest policy from the LDAP server.
Typically, Avaya Policy Manager will set this value whenever
there is a new policy to download. If this value is a non-zero
value, the LDAP client will compare it to the producer signal
on the LDAP server. No comparison is made if the value is
zero.
Indicates the success of the LDAP client when downloading a
policy. If the consumer signal matches the producer signal,
downloading LDAP to a policy was successful. If the consumer
signal is -1, then either the LDAP client had a problem
processing the access lists or the consumer signal set on the
LDAP client did not match the signal configured on the LDAP
server. If the consumer signal is not -1 and does not match the
producer signal, then the LDAP client was unable to connect to
the LDAP server(s).
To view configuration and LDAP statistics using the CLI, enter the
following command:
> show ldap
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
To configure a PPP Console static route:
1. Configure your console serial port as a PPP Console. Refer to
the
"Connecting a
and
Setup".
2. Select Static Routes from the Routing > IP >
Configuration folders on the Web Agent window. The IP
Static Routes dialog box opens (Figure 9-45).
Configuring IP Routing
Modem" section in Chapter 2,
"Initialize
9-109
Advertisement
Table of Contents
