Chapter 9
Parameter
Network Address
Mask
Next-Hop Address
Cost
Preference
Using the CLI
9-42
Figure 9-10. Add IP Static Route dialog box
2. Refer to Table 9-5 to configure the IP Static Route dialog
box parameters:
Table 9-5. IP Static Route Parameters
Allows you to...
Enter an IP network address for your IP static route.
Enter an IP subnet mask for your IP static route.
Enter an IP address for the gateway associated with
the IP static route.
Enter the metric between this router and the
destination.
Select a low or high routing preference from the
Preference field pull-down menu.
3. Click CREATE to save your changes, or CANCEL to restore
previous settings.
To create and show IP static routes using the CLI in configure mode:
<configure># ip route <ip-addr> <mask> <next hop
IP address> <cost> <preference>
<configure># show ip route static
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1