Routing Overview - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Routing Overview

Enhancement of the MAC Address Lock feature.

This feature has been available in all previous releases. If a

source MAC address is locked at a port (statically configured),

a frame with that source MAC will be filtered if received on

any other port on the same VLAN. With the enhancement,

the feature immediately generates traps to identify all

unknown source addresses. If, after sending a trap for an

unknown source, the switch continues to receive traffic from

the source, the feature generates a trap every 30 minutes

until the traffic stops.

* Note: You can set the trap timer within a range of 60

to 1800 seconds (default) in one second

For more information about the MAC Address Lock feature

and traps for unknown source addresses, see

Lock and Traps for Unknown Source Addresses"

Load MIB for the ATM Uplink module, V1.1 or later.

This feature makes it possible for you to use SNMP

commands to:

Upload the startup configuration file of the ATM Uplink

module to a TFTP server

Download the startup configuration file from a TFTP

server to the ATM Uplink module.

Download a software image to the ATM Uplink module.

All P550R/P580/P880/P882 Multiservice switches can be configured

as an IP, IPX, and AppleTalk router with virtual interfaces. Virtual

interfaces are mapped to physical ports or VLANs. Layer 3 IP traffic

is routed between the virtual interfaces.

Ports become members of VLANs by being assigned or by rules.

Multiple VLANs can share a single trunk port. In contrast, multiple

physical ports can be associated with a single VLAN. In all cases,

traffic that arrives and leaves the same VLAN is bridged, not routed.

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

"MAC Address

P550r P580 P880