Starting A Telnet Session - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Starting a Telnet Session

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1

* Note: You must be in Global Configuration mode and have

administrative privilege to enter the ip telnet port and ip

http port commands.

Use the following command to view the current TCP port settings

for Telnet and HTTP:

show tcp configuration

* Note: You must have administrative privilege to enter the show

tcp configuration command.

For more information about these commands, see Chapter 10, "IP,"

in the Command Reference Guide for the Avaya P550R, P580, P880, and

P882 Multiservice Switches, Version 5.3.1

Use the following MIB objects to change the TCP port for Telnet or

HTTP requests. These MIB objects are located in ProminetMib.txt,

version 5.2.

.iso.org.dod.internet.private.enterprises.prominet.

promPortMgmt.promTCPPortMgmt.promTCPPortHTTP

.iso.org.dod.internet.private.enterprises.prominet.

promPortMgmt.promTCPPortMgmt.promTCPPortTelnet

After changing the TCP port for Telnet requests to a port number

other than 23, you must specify the TCP port number in addition to

the IP address or host name to start a Telnet session.

For example, if you change the TCP port from 23 to 9998 on switch

192.168.0.126, enter telnet 192.168.0.126 9998 to start a Telnet

For more information about the telnet command, see "telnet" in

Chapter 31, "User Interface," in the Command Reference Guide for the

Avaya P550R, P580, P880, and P882 Multiservice Switches, Version 5.3.1.

Initialize and Setup

P550r P580 P880