Appendix A
CAUTION
Resetting the Active Supervisor
Web Agent
Procedure
A-8
When making configuration changes to the switch you must
save the changes you made by copying the running
configuration file to the startup configuration file. This
ensures that the changes persist after the switch is restarted.
When your switch is configured with a redundant
supervisor, you must also synchronize the supervisor
modules in order for both to have the same configuration
and reset the standby.
After setting the switch to load the new software at startup, you
must reset the switch. You can use either the Web Agent or CLI to
perform this task.
If the switch has a redundant supervisor module, resetting the
Active supervisor to load the new boot and application code forces
the Active supervisor to Standby, and the Standby supervisor to the
Active Supervisor mode. See, "Reset the Standby Supervisor", next
to change the Supervisor modes back to their original state.
To reset the switch after downloading new application software:
1. In the navigation pane, expand the System folder.
2. Select System Reset.
The System Reset Web page is displayed in the content
pane (Figure A-3).
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1