Avaya Cajun P882 User Manual page 340

Chapter 9
Parameter
Interface Type
Tunnel Endpoint Address
Interface Metric
Src Host Addr in Prune Msg
Interface Scope
Modifying the
DVMRP
Interface Using
the CLI
9-58
Table 9-9. DVMRP Interface Parameters
Defines the...
Select an Interface type. You can configure the
interface type as:
• Broadcast - All traffic is forwarded through the
• Non-Encapsulated Tunnel - All multicast data
• IPIP Tunnel - All multicast traffic (data and
Displays the Tunnel endpoint IP address of a router.
You can modify this setting to represent the end router
IP address to which you want to send datagrams
through a tunnel. The origin and endpoint routers are
separated by a gateway(s) or a router(s) that do not
support DVMRP.
Displays the Cost metric for the interface.
Select Disable to send prune messages with only the
subnet portion of the source address.
The default is Enable (sends prune messages with the
full source host address).
Select the minimum TTL (time-to-live) required for a
packet to leave this interface. The options are None,
127, and 255.
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To configure the DVMRP Interface using the CLI:
(configure-if:<interface># ip dvmrp <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
routers. This is not a tunnel and does not require
encapsulation.
traffic is IPIP encapsulated, but the protocol
messages are unicast.
protocol messages) are encapsulated in IP unicast
packets with the protocol set to IPIP (IP in IP).
2 of 2